Product Name: Switching Power Supply
Model Number: HTPSB140
Place of Origin: China

1.Input Characteristics:
a.Input voltage:110-230VAC±15%(90VAC-264VAC)
b.Input Frequency:50/60HZ±10%(45HZ--66HZ)
c.Fuse:A frse is included in the AC line circuit.The fuse rating is as to prevent
Safety hazard in the event of an intemal failure of the power supply. d.Inrush Current:<20A/ms. e.Earth Leakage Current:The earth leakage
current does not exceed 0.25mA at 264VAC 66Hz Input and the Min load condition.
f.Efficiency:75%min,at 220VAC input full load test. 2.Output Specification a.Output voltage:the +16V and +23V outputs are used for LNBP so that either of them
shall be loaded at a time output1 +3.30v /300-1500mA/+3.14V-3.46V( voltage limit)/5%tolerance/4.95Watt/ output2 +5.00/50-800mA/+4.75-5.25( voltage limit)/5%tolerance/4.0Watt output3 +12.0/0-100mA/+11.4-12.6( voltage limit)/5%tolerance/1.2Watt output4 +16.0/0-450mA/+15.0-17.0( voltage limit)/7%tolerance/7.2Watt output5 +23.0/0-450mA/+21.8-24.2( voltage limit)/5%tolerance/10.35Watt output6 +30.0/0-20mA/+27.9-32.1( voltage limit)/7%tolerance/0.6Watt b.Output Ripple:Measurement of ripple includes a 0.1uF ceramic capacitor and a 47uF
electrolytic capacitor at the output of measuring oscilloscope.Line ripple:measured
with an oscilloscope with a bandwidth of 100 MHZ.Switching ripple:measured with an oscilloscope with a bandwidth of 100MHZ. Output1\2\3:50mV at peak-peak line Ripple;200mV at peak-peak Switching Ripple. Output4\5\6:100mV at peak-peak line Ripple;200mV at peak-peak Switching Ripple.
c.Turn on delay time:1S max,at normal line full load. d.Hold on time:20mS min,at 220Vac line max load. e.Over Current Protection:The power supply protects itself from any over current
conditon. f.Thermal Protection:The power supply Protects itself down if it overheats.It resets
itself with no operator inventon. g.Shorted Output:All output with stand an indefinite short to Gnd,under any load
condition on the other output. h.HI-pot Test:Dielectric Withstand Voltage ACinputL.N to all output connectors 3000VAC
for 1 minute TEST. i.Burn-In:All power supplies will go through 4 hours of burn-in at 40 temperature
chamber under the nominal input and 80% of the maximum load condition,before delivery
to AMP. j.PCB Dimensions and Weight:Size:144*59*26(L*W*H).Weight:0.20kg MAX